Category Archives: wifi wall socket

WIFI Smart Socket

Smart socketIt looks like Itead have done it again – another winner – well that’s all down to the price and I’ll leave you to look that one up…the site says £9.76 for the unit which is reasonable – but I didn’t check postage.

The first modern WIFI wall socket I had was the Orbvibo Smart socket. I could not re-program it but I did manage to get Node-Red to talk to it over a websocket interface. I think it lasted a week before losing the info, then I discovered that Amazon had stopped selling them because of some regulation or other.  Not a nice experience – but they DID look nice.

Smart Socket[6]Similarly – the Itead  unit is good looking (though you would not tell it was theirs based on the one I have – there’s no reference to Itead on there at all and there were no instructions in the (very pretty) box. Probably because this is new (but available). This is an EU socket not UK so if you’re in the UK you’ll need a simple adaptor unless you want to live dangerously.

There is a programming button – which handily goes to GPIO0 on the ESP8266. Again a slight gripe here, once again they’ve Smart Socket[8]used a 1MB FLASH -  fine for their purposes but if ONLY they’d used the same as the ESP-12 (4MB) I could have done OTA – I believe there is other software that might be suitable which fits into the smaller space. However – not that big a deal. When my new 4MB Flash chips turn up I may just replace theirs.

pinsThe Smart Socket is designed to work with Itead’s APP – and if that’s what you want – read no further. It makes for a nice cheap WIFI controlled socket.

In my case of course I wanted it to work with our own software and hence remotely over Node-Red and MQTT – I suspect readers in here will want the same. So – out with the screwdriver – it turns out this was to be incredibly simple, once screw then finger-nails in the edge and it pops open  – there’s a 4-way set of holes which you can just shove wires into – ground, TX, RX and VCC.  I applied the relevant wires from my FTDI (obviously RX to TX etc)  to the holes – ensuring that [a] my finger was on the programming button at the time and [b] my FTDI was set to 3v3 – not 5v (important).  I blew the ROMs into the unit – this is covered elsewhere in the blog and is easy) and lo – one WIFI controlled switch I can control over MQTT etc.

I mean – it was that easy  - I’m missing the bit out about making a  change to my program to slow the flashing light down as the lights in this thing are BRIGHT.  So the green light is the general indicator (GPIO13) which I use all the time (thank heavens) and as in the SONOFF they use GPIO12 for the relay AND a nice blue light – so when the unit is running it is flashing green – if the output is on there is also a blue glow. Very nice.

So – there you have it – another winner.   It’s all down to postal charges really… oh, the relay claims 2KW – I’ll leave it up to someone else to see if it is up to that – I’d suggest that putting a 2KW electric heater on it will probably not work too well. It would be nice if a 1KW heater would work… anyone up to testing that ?